FAA STD- Engineering Drawing Preparation and Support (2005)

Keywords engineering drawing engineering drawing preparation FAA STD preparation and support

3.1.4 Title Block.

The title block shown in Figure 3-3, Drawing Title Block, is used for recording drawing data. The title block is located in the lower right corner and just inside the drawing zone boundary. It is sub-divided into rectangular areas that contain specific text data such as drawing title, drawn by, approved by, date and drawing number. All text in the title block shall be in upper case. The title block in Figure 3-3 is subdivided into three main sections. The revision section is located at the top. The authorizing agency section is located in the middle and the main section at the bottom. The main section of the title block contains the title, signatures, drawing identification and the issuing office. All title blocks for drawing sizes D to F must conform to Figure 3-3. The title block overall dimensions are 7-3/8” x 5-5/16”.

Document identifier
Date published
Document type
military standard
Defines standard
Replaced/Superseded by document(s)
Cancelled by
Amended by
File MIME type Size (KB) Language Download
FAA STD- Engineering Drawing Preparation and Support (2005).pdf application/pdf   1.22 MB English DOWNLOAD!
File attachments
Cover images

1.1 Standards.
This standard prescribes general requirements for the preparation and revision of architectural and engineering drawings that are prepared for facilities by and for the Federal Aviation Administration (FAA), using the two FAA-accepted CADD software suites, AutoDesk AutoCAD and Bentley MicroStation.
1.2 Classification.
This standard shall apply, but not be limited to the following drawing types regardless of source:
a) Construction drawings for new and existing facilities.
b) Installation drawings for electronic equipment.
c) FAA Standard engineering drawings.

Visit also